Nuovo Kafuter K-0272 High Intensity Screw Glue Anaerobic Adhesive for RC Model


Free Shipping

Kafuter K-0272 High Intensity Screw Glue Anaerobic Adhesive for RC Model


Per confermare che questa parte si adatta al tuo veicolo, inserisci i dettagli del tuo veicolo di seguito.

  • Anno:

    Si prega di selezionare

    • Fare:

      Si prega di selezionare

      • Modello:

        Si prega di selezionare

        • Sotto modello:

          Si prega di selezionare

          • tagliare:

            Si prega di selezionare

            • Motore:

              Si prega di selezionare

              • Resetta tutto
              Questa parte è compatibile con 0 veicolo(i).
              Mostra tutti i veicoli compatibili
              Questa parte è compatibile con 1 veicolo(i) coordinato
              Questa parte non è compatibile con
              Ricerche recenti

                • Anno
                • Fare
                • Modello
                • Sotto modello
                • tagliare
                • Motore

                  The anaerobic thread locking to avoid loosening and leakage of threaded fasteners. For M6-M36 thread locking and sealing. Prevent thread corrosion.
                  Typical uses: screw locking. 
                  Base chemical composition: methyl methacrylate 
                  Appearance: Red viscous liquid 
                  Viscosity (mPa.s): 8000-15000 
                  Specific Gravity: 1.12
                  Flash point (° C):> 93
                  Maximum fill the gap (mm): 0.25
                  Room temperature curing time (min): ≤ 15
                  After curing properties: 
                  Full cure time at room temperature (hr): 24 
                  Destruction of torque (Nm): ≥25
                  The average removal torque (Nm): ≥20 
                  Operating Temperature (° C): -54 ~ 203
                  Instructions for use: 
                  painted surfaces should be clean, dry and no oil. 
                  bolts painted in sufficient quantity to fill all engaged threads, a thin layer of the product results in a 0.05 mm or less work best. 
                  For large thread sizes, the larger the gap will affect cure speed and strength of the product. This product will reduce the friction force (torque tension ratio) assembly generated. Need to be fastened to the threaded applications critical value, the need to determine in advance a good ratio. 
                  The anaerobic thread locking should not be used on plastic parts; in order to avoid contamination of the original glue, do not have poured the glue back to the original packaging. 
                  Safety Precautions: 
                  The anaerobic thread locking containing methyl acrylate, skin and eye irritation. If skin contact, immediately wash with water; If contact with eyes, rinse immediately with water and go to the hospital for treatment. 
                  Storage conditions: in the temperature range of 15 ~ 28 ° C in a cool, dry place sealed, shelf life of up to 12 months.
                  Packing Included:
                  1 x Kafuter K-0272